User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Base Station Configuration Tsunami MP.16 3650 System User Guide
Networking Configuration
58
Syslog
Overview
When Secondary Management is enabled on the SS, the MP.16 supports Syslog functionality. Up to two Syslog servers
can be configured, each offering the following alert levels:
Each Syslog message includes a time-stamp, the severity level, and a brief description of the event. Supported Syslog
messages are as follows:
Syslog Configuration
From the Syslog Configuration page, you can enable or disable Syslog server functionality.
Alert Type Severity Level
Emergency 0
Alert 1
Critical 2
Error 3
Warning 4
Notice 5
Informational 6
Debug 7
Description Severity Additional Information
TFTP upload request failed Alert (1)
TFTP upload request successful Warning (4)
TFTP download request failed Alert (1)
TFTP download request successful Warning (4)
System manually rebooted Alert (1)
System cold/warm start Alert (1) BS Only
Event log reset Warning (4)
Interface up Alert (1) Includes interface number
Interface down Alert (1) Includes interface number
SS link lost Alert (1) BS Only
SS modulation dropped to BPSK ½ Critical (2)
SS RSSI dropped below low threshold Critical (2)
SS RSSI increased above high threshold Critical (2)
GPS not present Alert (1) BS Only
GPS lock lost Alert (1) BS Only