User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Base Station Configuration Tsunami MP.16 3650 System User Guide
Networking Configuration
56
Configuring the BS for Transparent VLAN Mode
Figure 3-11 Bridge Parameters (Transparent Mode)
1. Set the VLAN Mode to Transparent.
NOTE: The VLAN Priority and Management VLAN ID fields are not configurable when VLAN Mode is set to
Transparent.
2. Set Repeating Mode to Enable or Disable. When enabled, the BS allows traffic to be bridged between SSs.
Configuring the BS for Trunk VLAN Mode
1. Set the VLAN Mode to Trunk.
Figure 3-12 Bridge Parameters (Trunk Mode)
NOTE: If you have not added VLAN IDs to the VLAN ID List, an error message will be displayed. For information on
configuring the VLAN ID List, see VLAN ID List.