User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Base Station Configuration Tsunami MP.16 3650 System User Guide
Networking Configuration
50
Networking Configuration
Network configuration includes the following:
• Basic Networking
• VLANs
• Bridging
• RADIUS Servers
• Syslog
• Trap Hosts
• Static Routes
Basic Networking
Basic networking configuration involves setting the parameters of the BS’s Ethernet interface.
Figure 3-7 Basic Networking Parameters
The following parameters may be set or viewed:
• Ethernet Speed and Transmission Mode: This parameter is set to auto-speed-auto-duplex. It is not configurable.
• Ethernet IP Address: Set the static IP address of the BS. The default IP address of the BS is 192.168.10.1.
• Ethernet Subnet Mask: Set the subnet mask to which the unit is connected. The default mask is 255.255.255.0.
• Mcast Max Sustained Data Rate: Set the maximum sustained data rate on multicast packets. This parameter can be
set to unlimited, or to a value between 8 - 8192 Kbps (in multiples of 8 Kbps).
• VLAN Mcast Max Sustained Data Rate: Set the maximum sustained data rate on multicast packets sent across a
VLAN. This parameter can be set to unlimited, or to a value between 8 - 1024 Kbps (in multiples of 8 Kbps).
• Gateway IP Address: Enter the IP address of a gateway on the network.