User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Installation and Initialization Tsunami MP.16 3650 System User Guide
First Configuration
41
First Configuration
The MP.16 system operates with little required setup. However, the administrator must initially configure certain
parameters to allow the BS and SS to communicate and (if desired) to secure the network.
The following parameters must be set in order for the units to communicate:
• Center frequency: On the BS and SS Web interfaces, click Configuration > Radio to set the desired frequency.
See the following:
– Radio Configuration in the Base Station Configuration chapter
– Radio Configuration in the Subscriber Station Configuration chapter.
The following parameters must be set to ensure that the network is secure:
• IP address:
– On the BS Web interface, click Configuration > Networking > Basic to set the IP address. See Networking
Configuration in the Base Station Configuration chapter.
– On the SS Web interface, click Configuration > Network to set the IP address. See Networking Configuration in
the Subscriber Station Configuration chapter.
• Passwords: On the BS Web interface, click Commands > Passwords to set HTTP and CLI passwords. See
Passwords in the Commands on BS/SS chapter.
• Net Entry mode: On the BS Web interface, click Configuration > SS Authentication to set the Net Entry Mode. See
Subscriber Station Authentication in the Base Station Configuration chapter.
More information and advanced configuration options can be found as follows:
• For information and advanced Web-based configuration on the BS, including the use of Service Classes, see Base
Station Configuration.
• For information and advanced Web-based configuration options on the SS, see Subscriber Station Configuration.
• For information on configuration via the CLI, see Command Line Interface.