User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Installation and Initialization Tsunami MP.16 3650 System User Guide
Using the Web Interface
38
4. Click on any of the menu items on the left side of the screen to begin configuring the unit.
Web Interface Navigation
The Web interface screen contains two sections (see Figure 2-5):
• Menu: Use the collapsible menu on the left of your screen to navigate through the web interface. For headings
(marked with a folder icon: ) click on the arrow to the left of the heading to expand its contents ( ). Configuration
pages (marked with a page icon: ) are used for configuring the unit.
NOTE: You must click on an item with a page icon ( ) to display configuration parameters; if you click on an
expanded heading ( ), the screen will not update.
• Configuration parameters: View and change the unit’s settings in the “work area.” Enter required or desired values in
available fields, or use drop down menus to make selections. When you have configured a page, you must click the
OK button to save your changes. If you do not click the OK button, the configuration parameters you specified will not
be set.
Figure 2-5 Web Interface Screen (Base Station)
Configuration/Monitoring
parameters
Menu