User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Installation and Initialization Tsunami MP.16 3650 System User Guide
Using the Web Interface
37
Using the Web Interface
Logging In
You may use your web browser to monitor and configure the radio unit. To configure and monitor the unit using the
command line interface, see Command Line Interface.
1. Open a Web browser on a network computer.
2. Enter the unit’s IP address in the browser’s Address field and press Enter or Go.
• The default IP address of the BS is 192.168.10.1.
• The default IP address of the SS is 192.168.10.2.
NOTE: The unit must be on the same subnet as your network computer. The default subnet for the BS is
255.255.254.0; the default for the SS is 255.255.255.0.
The login page is displayed.
Figure 2-3 Enter Network Password
3. Log in as follows:
• To log in as an administrator, enter “admin” in the User Name field. Enter the password in the Password field.
For new units, the default administrator password is public.
• To log in as a user, enter “user” in the User Name field. Enter the password in the Password field. For new units,
the default password is public.
NOTE: To change passwords via the web interface, see Passwords in the Commands on BS/SS chapter. To change
passwords through the CLI, see Passwd Command in the Command Line Interface chapter.
Upon successful login, the System Overview page is displayed, containing read-only information about your BS or SS.
Figure 2-4 System Overview Page (Base Station)
You can configure many of the parameters displayed on this page from the System Configuration page. To return to
this page at any time, click MP.16 BS (Admin Logon) or MP.16 SS (Admin Logon) on the menu.