User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Installation and Initialization Tsunami MP.16 3650 System User Guide
Hardware Installation
25
Hardware Installation
This section describes the steps required to install and mount the unit, and to align the antenna. The installation
procedure does not include the mounting and connection of antennas. See the documentation the accompanies the
antenna and the Tsunami MP.16 3650 System Antenna Installation Guide for this information.
NOTE: Be sure to read the Release Notes file on the product CD as it contains software version and driver information
that may not have been available when this document was produced.
NOTE: Equipment is to be used with, and powered by, the power injector provided or by a power injector that meets
these requirements:
• UL-Listed/ITE (NWGQ)
• Limited Power Source Output per UL/IEC 60950
• CE-marked
• Approved for Power-over-Ethernet
• Rated output, 48 Vdc/0.67 A
• Pinout follows 802.3af standard for mid-span devices
See the following sections for installation instructions:
• Step 1: Choose a Location
• Step 2: Unpack Shipping Box
• Step 3: Assemble the Cable
• Step 4: Determine Proper Mounting Orientation
• Step 5: Assemble Mounting Hardware
• Step 6: Mount the Unit
• Step 7: Plug in the Cables
• Step 8: Power on the Unit
• Step 9: View LEDs
• Step 10: Align the Antenna
• Step 11: Tighten the Cables
IMPORTANT:
Before installing and using this product, see Safety and Regulatory Compliance Information on the
product CD.
IMPORTANT:
All units must be installed by a suitably trained professional installation technician or by a qualified
installation service.
WARNING:
To ensure proper grounding, use the hole at the bottom point on the back of each unit and the provided
grounding screws to attach a ground wire of at least 10 AWG stranded to each unit. Use proper wire
grounding techniques in accordance with local electric codes.