User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Installation and Initialization Tsunami MP.16 3650 System User Guide
Hardware Description
20
Power Adaptor LED
An LED is provided on top of the power adaptor, as shown in the following figure.
Figure 2-2 Power Adaptor LEDs
When the LED is green, the power is on.
Antennas
Some Tsunami MP.16 3650 units have integrated antennas, while others have external antenna connectors (Type-N) and
no integrated antennas. External connector specifications are as follows:
For more information on external antennas, see the Tsunami MP.16 3650 System Antenna Installation Guide and the
Tsunami MP.16 System Recommended Antennas guide.
Serial Connection
The serial connection is used for issuing CLI commands using a terminal emulator. The serial connection is made with an
RJ45 to DB9 connector (also referred to as a “dongle”). During Hardware Installation, plug the RJ45 end of the dongle
into the GPS/SYNC port of the radio and connect the serial end to your PC.
The serial dongle also includes an in-line stereo jack to aid in antenna alignment (upcoming feature).
Connections are as follows:
Characteristic Limit
Connector type Type-N, female
Impedance 50 Ohms over the operating frequency band
Antenna Return Loss -10 dB maximum
DC Resistance DC resistance to ground less than 1 Ohm
In-Line
Stereo Jack
DB9
Connector
RJ45
Plug
NC NC 1
NC 5 2
NC 5 3
NC 2 4