User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Command Line Interface Tsunami MP.16 3650 System User Guide
Monitoring the BS and SS: Software Version
159
Monitoring the BS and SS
• Software Version
• Network Status (SS only)
• Software Version
• Base Station Statistics
• Subscriber Station Statistics
Software Version
You can view the version number of the application image and the firmware version number on both the BS and the SS.
Log into the BS or SS and enter the following command:
MP16>show version
Network Status (SS only)
You can view the network status of the SS. Log into the BS or SS and enter the following command:
MP16>show status
Log Messages
A message log is available on both the BS and SS.
Common Log Messages
The following log messages shall be supported on both the Subscriber Station and the Base Station:
Base Station Log Messages
The following log messages shall be supported in the Base Station:
Subscriber Station Log Messages
The following log messages shall be supported at the Subscriber Station:
Log Message Severity
Invalid HTTP Login Warning
Invalid SNMP Community Warning
Invalid CLI Login Warning
Log Message Severity
Subscriber station xx:xx:xx:xx:xx:xx successfully entered the network Informational
Subscriber station xx:xx:xx:xx:xx:xx authorization failure Warning
Subscriber station xx:xx:xx:xx:xx:xx exited the network Informational
Subscriber station xx:xx:xx:xx:xx:xx adapted uplink/downlink from y to z. (e.g., y,z = BPSK-1/2) Informational
No response from Radius Server Alert
Service Flow xxxx successfully activated Informational
Subscriber station xx:xx:xx:xx:xx:xx power adjusted by # dB Informational
Log Message Severity
Subscriber station adjusted power by # dB Informational