User's Manual

Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Subscriber Station: Subscriber Station Device Configuration
156
Configuration from the Subscriber Station
Log into the Subscriber Station and use the configure, delete, set, and show commands to set or view local SS
parameters. See the following sections:
• Subscriber Station Device Configuration
• Radio Configuration
• Logging Configuration
Subscriber Station Device Configuration
To configure the individual SS parameters, enter the following command from the root prompt:
MP16>configure ss
The prompt will change to:
MP16(ss)>
From the ss prompt, you can show or set parameters in the following groups:
• Device Parameters
• IP Addresses/Masks
Device Parameters
IP Addresses/Masks
To set the IP Address and Mask:
MP16(ss)>set ipaddr <interface> <ipaddress> <mask>
where <interface> is Ethernet (enet0).
To set the Default Gateway:
MP16(ss)>set dfltgw <ipaddress>
Radio Configuration
To configure the radio parameters for an SS, enter the following command from the root prompt:
Name Type Values Access Parameter
Name DisplayString 1 – 255 alphanumeric
characters
RW sysname
Location DisplayString 1 – 255 alphanumeric
characters
RW location
Contact Name DisplayString 1 – 255 Alphanumeric
characters
RW contact
Contact Email DisplayString 1 – 255 alphanumeric
characters
RW emailid
Contact Phone Number DisplayString 1 – 255 alphanumeric
characters
RW phone
Name Type Values Access Parameter
IP Address IP Address Valid IP address RW ipaddr
Default Gateway IP Address — RW dfltgw