User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Base Station: Trap Host Parameters
154
Trap Host Parameters
To configure the Trap Host parameters, you must first add a Trap Host. Enter the following command from the root
prompt:
MP16>add traphost <IP Address>
To configure the added Trap Host, enter the following command from the root prompt:
MP16>configure traphost <IP Address>
The prompt will change to:
MP16(trap host IP Address)>
Management Interface Parameters
To configure the management interface parameters, enter the following command from the root prompt:
MP16> configure mgmtinterface
The prompt will change to:
MP16(configure-mgmtinterface)>
Name Type Values Parameter
Volatile Log Status Integer enable
disable
vlogstatus
Non-Volatile Log Status Integer enable
disable
nvlogstatus
Volatile Log Filter Level Integer none
emergency
alert
critical
error
warning
notice
informational
debug
all
vloglevel
Non-Volatile Log Filter Level Integer none
emergency
alert
critical
error
warning
notice
informational
debug
all
nvloglevel
Name Type Values Access Parameter
IP Address IP Address User defined RW —
Password DisplayString User defined W password
Status Integer enable
disable (default)
RW status
Comment DisplayString User defined RW comment