User's Manual

Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Base Station: Logging Configuration
153
Ethernet Type/Value (ethertype)
The Ethernet Type parameter designates the Ethernet type on which the filtering is to be done. To add an Ethernet type
entry:
MP16(PIR Name)>add ethertype <value> <Ethernet Protocol Type>
where <value> is dix_snap or dsap, and <Ethernet Protocol Type> is a 16-bit value if dix_snap is selected, and an 8-bit
value if dsap is selected. Ethernet protocol type can be one of the following:
• 0200 (Xerox PUP)
• 6001 (DEZ MOP)
• 8005 (HP Probe)
• 809B (AppleTalk)
Execute a show command to view Ethernet type:
MP16(PIR Name)>show ethertype
To delete the Ethernet type:
MP16(PIR Name)>delete ethertype
Ethernet Priority (ethernetpriority)
The Ethernet priority parameters are under the group ethernetpriority. To add an entry:
MP16(PIR Name)>add ethernetpriority <Ethernet priority low> <Ethernet priority high>
where <ethernet priority low> and <ethernet priority high> are values in the range 0 - 7.
Execute a show command to view Ethernet priority:
MP16(PIR Name)>show ethernetpriority
To delete the Ethernet priority:
MP16(PIR Name)>delete ethernetpriority
VLAN ID (vlanid)
The VLAN ID designates the VLAN on which the filtering is to be done. To add a VLAN ID:
MP16(PIR Name)>add vlanid <value>
where <value> is a number between 0 – 4095 (0 = unused).
To delete the VLAN ID:
MP16(PIR Name)>delete vlandid
Logging Configuration
To configure logging related parameters, enter the following command at the root prompt:
MP16>configure log
The prompt will change to:
MP16(log)>
From the log configuration prompt, you can set or show the following logging configuration parameters: