User's Manual

Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Base Station: Service Class Creation
150
Blocked (blocked)
When the blocked parameter is enabled, packets matching the classifiers configured below are blocked. When disabled,
packets matching the classifiers configured below are allowed. Use the following syntax:
MP16(PIR Name)>add blocked <enable/disable>
IP Type of Service (iptos)
The IP Type of Service parameters are under the group iptos. To add IP Type of Service entries, use the following
syntax:
MP16(PIR Name)>add iptos <iptos low value> <iptos high value> <iptos mask value>
where all values are between 0 and 255.
Execute a show command to view the value of the IPTOS parameters:
MP16(PIR Name)>show iptos
To delete iptos entries:
MP16(PIR Name)>delete iptos
IP Protocol List (ipproto)
The IP Protocol list is grouped under ipproto. Up to 16 entries can be added to this list. To add entries:
MP16(PIR Name)>add ipproto <value>
where <value> is a number between 1 – 255.
IP Type of Service Integer See IP Type of Service
(iptos)
RW iptos
IP Protocol List Table See IP Protocol List
(ipproto)
RW ipproto
IP Source & Mask List Table See IP Source Address
and Mask List (scrcipaddr)
RW srcipaddr
Ethernet Source MAC and
Mask
Table See Ethernet Source MAC
Address and Mask
(srcmacaddr)
RW srcmacaddr
Protocol Source Port Range Table See Protocol Source Port
Range (srcport)
RW srcport
IP Destination & Mask List Table See IP Destination
Address and Mask List
(destippaddr)
RW destipaddr
Ethernet Destination MAC and
Mask
Table See Ethernet Destination
MAC Address and Mask
(destmacaddr)
RW destmacaddr
Protocol Destination Port
Range
Table See Protocol Destination
Port Range (destport)
RW destport
Ethernet Type/Value Table See Ethernet Type/Value
(ethertype)
RW ethertype
Ethernet Priority Integer See Ethernet Priority
(ethernetpriority)
RW ethernetpriority
VLAN ID Integer See VLAN ID (vlanid) RW vlanid
Name Type Values Access Parameter