User's Manual

Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Base Station: Base Station Parameters
133
Base Station Parameters
Parameters that affect the Base Station only are grouped under Base Station. To configure the parameters under the
Base Station group, you must get into the Base Station configuration prompt, which is done by entering the following
command:
MP16>configure bs
The prompt will change to:
MP16(bs)>
From the bs configuration prompt, you can show or set parameters in the following categories:
• Base Station Device Parameters
• SS Authentication
• Networking
• VLAN Mode/Management ID
• Static IP Routes
Base Station Device Parameters
* These values will reset to default upon unit reboot.
SS Authentication
Networking
Name Type Values Access Parameter
Base Station ID MAC Address 48 bits
(default = 00:00:00:00:01)
RW bsid
Name Display String 1 – 255 alphanumeric characters RW sysname
Location Display String 1 – 255 alphanumeric characters RW location
Contact Name Display String 1 – 255 alphanumeric characters RW contact
Contact Email Display String 1 – 255 alphanumeric characters RW emailid
Contact Phone No. Display String 1 – 255 alphanumeric characters RW phone
Current Date and Time* Display String YYYY:MM:DD:HH:MM R/W* datetime*
Up Time Time Ticks 0 – 65535 R sysuptime
Name Type Values Access Parameter
Net Entry Mode Integer unrestricted (default)
int
ext
RW accessmode
Default SS Class Display String Any defined SS Class RW dfltss
Name Type Values Access Parameter
IP Address/Mask IP Address Valid IP address RW ipaddr
Maximum Multicast
Downlink
Integer Unlimited
8 - 8192 Kbps (in multiples of 8
kbps)
RW maxmcastdl
Maximum VLAN
Multicast Downlink
Integer Unlimited
8 - 8192 Kbps (in multiples of 8
kbps)
RW maxvlanmcastdl