User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Command Line Interface Tsunami MP.16 3650 System User Guide
CLI Overview: Commands
131
Upload Command
Use the upload command from the root prompt to transfer the configuration file from the Base Station to the TFTP
server.
To upload a configuration file from the BS to the TFTP server, use the following syntax:
MP16>upload <TFTP server address> <path or filename>
NOTE: If the file is located in the TFTP root directory, you do not need to enter a path. However, if the file is located in
a sub-level of the TFTP directory, enter the entire path, beginning with a back slash (\) and containing both the
path and the file name.
For example:
MP16>upload 135.85.199.10 config.bin
MP16>upload 135.85.199.10 \config\config.bin
Exit Command
Use the exit command as follows:
• From the root prompt: disconnect and close the CLI.
• From the configure prompt: return to the root prompt.
NOTE: Pressing CTRL-Z will also exit from a configuration prompt and return to the root-level prompt.