User Manual

Configuration MP.11-R Installation and Management

Interface Parameters

• Rx Inactivity Timeout: This is the activity time-out of an SU on a BSU.

• Network Secret: A network secret is a secret password given to all nodes of a network. An SU can only register to a

BSU if it has the same Network Secret. The Network Secret is sent encrypted and can be used as a security option.

• Input / Output Bandwidth Limit: These parameters limit the data traffic received on the wireless interface and

transmitted to the wireless interface, respectively. Selections are in steps of 64 Kbps from 64 Kbps to 108,064 Kbps.

• Dynamic Data Rate Selection (DDRS) Status: Select the DDRS Status “Enable” or “Disable” from the drop-down

box provided. When you enable or disable DDRS on the BSU, the BSU sends an announcement to the SUs and the

SUs enable or disable DDRS automatically.

• DDRS Default Data Rate: When DDRS is enabled, configure the default data rate. Possible values are (normal

mode): 6 Mbps, 9 Mbps, 12 Mbps, 18 Mbps, 24 Mbps, 36 Mbps.

• DDRS Max Data Rate: When DDRS is enabled, configure the maximum data rate that can be dynamically set by

DDRS. Possible values are (normal mode): 6 Mbps, 9 Mbps, 12 Mbps, 18 Mbps, 24 Mbps, 36 Mbps.

• DDRS Avg SNR Threshold for Data Rate Increase: When DDRS is enabled,???

• DDRS Reg SNR Threshold for Data Rate Increase: When DDRS is enabled,???

• DDRS Avg SNR Threshold for Data Rate Decrease: When DDRS is enabled,???

• DDRS Inc Percent Threshold: When DDRS is enabled,???

• DDRS Dec Percent Threshold: When DDRS is enabled,???

Additionally, the BSU screen for countries that require DFS contains the sections described below.