Spec Sheet

Specifications: Tsunami® Multipoint 820 series
Copyright © Proxim Wireless Corporation. All rights reserved.
www.proxim.com
PRODUCT MODELS
MP-820-BSU-100 Tsunami® MP 820 Base Station Unit, 100 Mbps, MIMO 2x2, N-Type Connectors
MP-825-BS3-100 Tsunami® MP 825 Base Station Unit, 100 Mbps, MIMO 2x2, 15 dBi Antenna
MP-820-SUA-50
+
Tsunami® MP 820 Subscriber Unit , 50 Mbps (upgradable to 100 Mbps), MIMO 2x2, N-Type Connectors
MP-820-SUA-100 Tsunami® MP 820 Subscriber Unit , 100 Mbps, MIMO 2x2, N-Type Connectors
MP-825-SUR-50
+
Tsunami® MP 825 Subscriber Unit , 50 Mbps (upgradable to 100 Mbps), MIMO 2x2, 15 dBi Antenna
MP-825-SUR-100 Tsunami® MP 825 Subscriber Unit , 100 Mbps, MIMO 2x2, 15 dBi Antenna
INTERFACES
WIRED ETHERNET One auto MDI-X RJ45 10/100/1000Mbps Ethernet with PoE in
WIRELESS PROTOCOL WORP® (Wireless Outdoor Router Protocol) or WORP sync
RADIO & TX SPECS
MIMO 2x2 MIMO
MODULATION OFDM with BPSK, QPSK, QAM16, QAM64
FREQUENCY 5.150 – 5.925 GHz (Subject to Country Regulations)
CHANNEL SIZE 40 MHz, 20 MHz, 10 MHz*, 5 MHz* channel bandwidths * Not applicable for DFS Band
DATA RATE MCS 0 to 15 for High Throughput mode (6.5 – 300 Mbps) with Dynamic Data Rate Selection. BPSK, QPSK, 16-QAM and 64-QAM for legacy mode (6Mbps - 54Mbps)
TX POWER Up to 26 dBm (dual chain)
TX POWER CONTROL 0 – 15 dB, in 0.5 dB steps. Automatic TPC with configurable EIRP limit
OTHER Dynamic Channel Selection (DCS) based on interference detection. Dynamic Frequency Selection (DFS) based on radar signature. Automatic Transmit Power Control (ATPC) with EIRP limit support
RX SENSITIVITY (BER=10
-6
)
Channel Size 40 MHZ 20 MHZ 10 MHz 5 MHz
MCS 0 -88 dBm -92 dBm -93 dBm -94 dBm
MCS 7 -72 dBm -74 dBm -75 dBm -77 dBm
MCS 8 -88 dBm -91 dBm -93 dBm -94 dBm
MCS 15 -69 dBm -71 dBm -72 dBm -75 dBm
SYNCHRONIZATION
Synchronize internal clock to Pulse Per Second signal received from either GPS module connected to RJ11 serial port or Ethernet Synchronization module connected to RJ45 ethernet port
ANTENNA
MP-820-BSU-100/SUA-50
+
/SUA-100: Two N-type connectors
MP-825-BS3-100/SUR-50
+
/SUR-100: Integrated 15 dBi dual Polarized (H+V) panel antenna (14 dBi beyond 5.850 GHz)
MANAGEMENT
LOCAL RS-232 serial (RJ11 to DB-9 dongle provided)
REMOTE Telnet and SSH, Web GUI and SSL, TFTP, SNMPv3
SNMP SNMP v1-v2c-v3, RFC-1213, RFC-1215, RFC-2790, RFC-2571, RFC-3412, RFC-3414, Private MIB
OTHER Syslog, sFlow™ agent, SNTP and local time, Spectrum analyzer
SECURITY
ENCRYPTION AES-CCM 128 bits
AUTHENTICATION Internal MAC Address Control List, Radius based Authentication (with VLAN and QoS provisioning)
NETWORK
MODES Bridging, Routing (RIP v2 and IP tunneling)
GATEWAY FEATURES DHCP Server & relay, NAT with Std ALGs, PPPoE end point with Proxy DNS
IP STACK IPv4 and IPv6 simultaneously
THROUGHPUT MP-820-BSU-100/SUA-100, MP-825-BS3-100/SUR-100: Up to 100 Mbps, 32 subscriber max
MP-820-SUA-50
+
or MP-825-SUR-50
+
: Up to 50 Mbps (license upgradable to 100 Mbps)
QoS
Asymmetric Bandwidth Control Uplink and Downlink CIR Control “committed information rate” and MIR Control “maximum information rate” per service flow
Packet Classification Capabilities
802.1D/802.1Q/802.1p priority, IPTOS, VLAN ID, IP protocol, IP source/destination address, Ethernet source/destination address, source/
destination port, and Ethertype
Scheduling Best Eort, Real Time Polling Services
VLAN 802.1Q: Management VLAN. Transparent, Access, Trunk and Mixed mode. QinQ double tagging
POWER SUPPLY
Via provided PoE injector or directly from 12 VDC source through serial port
POWER CONSUMPTION
6 Watt typical (15 Watt max)
ENVIRONMENTAL SPECS
OPERATING TEMPERATURE STORAGE TEMPERATURE HUMIDITY, WATER & DUST PROOF, WIND LOADING
-40º to 55ºC (-40º to 131º Fahrenheit) -55º to 70ºC (-67º to 158º Fahrenheit) Max 100% relative humidity (non-condensing), IP67, 180 km/h (112 mph)
PHYSICAL SPECS
DIMENSIONS (PACKAGED) DIMENSIONS (UNPACKAGED)
MP-820-BSU-100/SUA-50
+
/SUA-100: 11.81x10.83x5.31 in (300x275x135 mm) MP-820-BSU-100/SUA-50
+
/SUA-100: 5.02x8.68x2.85 in (127.5x220.5x72.5 mm)
MP-825-BS3-100/SUR-50
+
/SUR-100: 11.81x10.83x5.31 in (300x275x135 mm) MP-825-BS3-100/SUR-50
+
/SUR-100: 4.96x8.62x2.58 in (126x219x65.5 mm)
WEIGHT (PACKAGED) WEIGHT (UNPACKAGED)
MP-820-BSU-100/SUA-50
+
/SUA-100: 7.93 lbs (3.6 kg) MP-820-BSU-100/SUA-50
+
/SUA-100: 2.75 lbs (1.250 kg)
MP-825-BS3-100/SUR-50
+
/SUR-100: 7.27 lbs (3.3 Kg) MP-825-BS3-100/SUR-50
+
/SUR-100: 2.10 lbs (0.950 kg)
SAFETY STANDARDS
UL 60950-1/22, CAN/CSA-C22.2 No. 60950-1/22, IEC 60950-1/22, EN 60950-1/22
PACKAGE CONTENTS
One Tsunami® MP-820-BSU-100 with two N-type surge protected connectors Or One Grounding kit
One Tsunami® MP-825-BS3-100 with 15 dBi integrated antenna Or One Wall / Pole mounting kit
One Tsunami® MP-820-SUA-50
+
/SUA-100 with two N-type surge protected connectors Or One Connector weatherproofing kit (Includes all recommended weatherproofing material)
One Tsunami® MP-825-SUR-50
+
/SUR-100 with 15 dBi integrated antenna One Serial (RJ-11 to DB9) dongle
One 32 W power injector with reload button and country specific power cord One Quick Installation Guide
MTBF & WARRANTY
>350,000 hours & 1-year; ServPak Extended Support available.