User's Manual Part 2

Commands MeshMAX 5054 Series User Guide
Command Functions for Subscriber Module
212
CAUTION: Rebooting the unit causes all users currently connected to lose their connection to the network until the
Subscriber unit has completed the reboot process and resumed operation.
Reset
Click Commands > Reset to restore the configuration of the Subscriber unit to the factory default values.
You can also reset the Subscriber unit by pressing the RESET button located on the side of the unit. Because this resets
the unit’s current IP address, a new IP address must be assigned.
CAUTION: Resetting the unit to its factory default configuration permanently overwrites all changes made to the unit.
The unit reboots automatically after this command has been issued.
Help Link
Click Commands> Help Link to set the location of the help files of the Web Interface. Upon installation, the help files are
installed in the C:\Program Files\Tsunami\[Model Name]\Help folder.
If you want to place these files on a shared drive, copy the Help folder to the new location and specify the new path in the
Help Link box.
Downgrade
Click Commands > Downgrade to downgrade to a previous release. Downgrade currently is supported only to release
2.0.1 and later. Once you enter this command, the unit is downgraded to the specified release and is automatically
rebooted. The filename specified and the filename of the image selected for downgrade must be the same version. The
unit will download the file, re-format the configuration to match the version, and reboot to put the image into effect.