User's Manual Part 2

Monitoring MeshMAX 5054 Series User Guide
Monitoring Options for Mesh and Access Point Module
198
Learn Table
Click Monitor > Learn Table to view all MAC addresses the Subscriber unit has detected on an interface. The Learn
Table displays information relating to network bridging. It reports the MAC address for each node that the device has
learned is on the network and the interface on which the node was detected. There can be up to 10,000 entries in the
Learn Table.
This tab is only available in Bridge mode.
RIP
Click Monitor > RIP to view Routing Internet Protocol data for the Ethernet and Wireless interfaces.
Monitoring Options for Mesh and Access Point Module
To monitor the AP using the HTTP/HTTPS interface, you must first log in to a web browser. See Logging In for
instructions.
You may also monitor the AP using the command line interface. See Command Line Interface (CLI) for more information
To monitor the AP via HTTP/HTTPS:
1. Click the Monitor button located on the left-hand side of the screen. The main Monitor screen will be displayed.