User's Manual Part 2

Configuration MeshMAX 5054 Series User Guide
Advanced Configuration of Mesh and Access Point Module
163
Policy
Perform the following procedure to enable QoS and add QoS policies:
1. Click Configure > QoS > Policy.
Figure 6-40 QoS Policy Sub-Tab
2. To enable QoS, check the Enable Quality of Service checkbox.
3. Configure the QoS Maximum Medium Threshold for all Admission Controls. Admission will be granted if the new
requested traffic stream and already admitted time is less than the medium maximum threshold.
4. To add a QoS Policy, click the Add button in the “QoS Policies Table” box. The Add Entries box appears.