User's Manual Part 2

CLI for Mesh and Access Point Module MeshMAX 5054 Series User Guide

User Guide

285

Configure Serial Port Interface

NOTE: To avoid unexpected performance issues, leave Flow Control at the default setting (none) unless you are sure

what this setting should be.

[Device-Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>

[Device-Name]>set serflowctrl <none, xonxoff>

[Device-Name]>show serial

Figure B-15 Result of “show serial” CLI Command

Configure Syslog

[Device-Name]>set syslogpriority <1–7 (default is 6)>

[Device-Name]>set syslogstatus <enable/disable>

[Device-Name]>set sysloghbstatus <enable/disable> (default is disable)

[Device-Name]>set sysloghbinterval <1–604800> (default is 900 seconds)

[Device-Name]>set sysloghosttbl <index> ipaddr <ipaddress> cmt <comment> status

Configure Intra BSS

[Device-Name]>set intrabssoptype <passthru (default)/block)>

Configure Wireless Distribution System

Create/Enable WDS

[Device-Name]>set wdstbl <Index> partnermacaddr <MAC Address> status enable

Enable/Disable WDS

[Device-Name]>set wdstbl <Index> status <enable/disable>

NOTE: <Index> is 3.1–3.6 (Wireless A) or 4.1–4.6 (Wireless B). To determine the index, type show wdstbl at the

prompt.

NOTE: When WDS is enabled, spanning tree protocol is automatically enabled. It may be manually disabled. If Spanning

Tree protocol is enabled by WDS and WDS is subsequently disabled, Spanning tree will remain enabled until it is

manually disabled. See Spanning Tree Parameters.

Configure MAC Access Control

Setup MAC (Address) Access Control

[Device-Name]>set wifssidtbl <index> aclstatus enable/disable

[Device-Name]>set macacloptype <passthru, block>

[Device-Name]>reboot 0

Add an Entry to the MAC Access Control Table

[Device-Name]>set macacltbl 0 macaddr <MAC Address> status enable

[Device-Name]>show macacltbl