User's Manual Part 2

CLI for Mesh and Access Point Module MeshMAX 5054 Series User Guide
User Guide
282
Configure DHCP Relay
Perform the following command to enable or disable DHCP Relay Agent Status.
NOTE: You must have at least one entry in the DHCP Relay Server Table before you can set the DHCP Relay Status to
Enable.
[Device-Name]>set dhcprelaystatus enable
Configure DHCP Relay Servers
Perform the following command to configure and enable a DHCP Relay Server. The AP allows the configuration of a
maximum of 10 server settings in the DHCP Relay Agents server table.
[Device-Name]>set dhcprlyindex 1 dhcprlyipaddr <ip address> dhcprlycmt <comment>
dhcprlystatus 1 (1 to enable, 2 to disable, 3 to delete, 4 to create)
Maintain Client Connections using Link Integrity
[Device-Name]>show linkinttbl (this shows the current links)
[Device-Name]>set linkinttbl <1–5 (depending on what table row you wish to address)>
ipaddr <ip address of the host computer you want to check>
[Device-Name]>set linkintpollint <the interval between link integrity checks>
[Device-Name]>set linkintpollretx <number of times to retransmit before considering the
link down>
[Device-Name]>set linkintstatus enable
[Device-Name]>show linkinttbl (to confirm new settings)
[Device-Name]>reboot 0
Change Wireless Interface Settings
See Interfaces for information on the parameters listed below. The AP uses index 3 for Wireless Interface A (802.11a
radio or 4.9 GHz radio) and index 4 for Wireless Interface B (802.11b/g radio).
Operational Mode
[Device-Name]>set wif <index> mode <see table>
Autochannel Select (ACS)
ACS is enabled by default. Reboot after disabling or enabling ACS.
[Device-Name]>set wif <index> autochannel <enable/disable>
[Device-Name]>reboot 0
Mode Operational Mode
1 dot11b-only
2 dot11g-only
3 dot11bg
4 dot11a-only
5 dot11g-wifi
6 publicsafety