User's Manual Part 1

Configuration MeshMAX 5054 Series User Guide

Configuring the Subscriber Module

Edit/Delete Entries in the IP Access Table

To edit or delete table entries, click the Edit/Delete Table Entries button, make your changes, and click OK.

RIP Parameters (Routing Mode Only)

Routing Internet Protocol (RIP) is a dynamic routing protocol you can use to help automatically propagate routing table

information between routers. The unit can be configured as RIPv1, RIPv2, RIPv1 Compatible, or a combination of the

three versions while operating in Routing mode. In general, the unit’s RIP module is based upon RFC 1389.

NOTE: The RIP tab is available for SUs in Routing mode only. RIP is configurable only when the unit is in Routing

Mode and Network Address Translation (NAT) is disabled.

Note the following: