User's Manual Part 1

Configuration MeshMAX 5054 Series User Guide

Configuring the Subscriber Module

Click Configure > Network > IP Routes to configure.

Add IP Routes

1. Click the Add button; the following screen is displayed.

2. Enter the route information.

3. Click Add. The IP Address and Subnet Mask combination is validated for a proper combination.

NOTE: When adding a new entry, the IP address of the Route Destination must be in either the Ethernet subnet or in the

wireless subnet of the unit.

Edit/Delete IP Routes

1. Click the Edit/Delete Table Entries button to make changes to or delete existing entries.

2. Edit the route information.

3. Click OK. The IP address and subnet mask combination is validated for a proper combination.