User's Manual Part 1

System Status MeshMAX 5054 Series User Guide
Mesh and Access Point Module
62
Figure 5-2 Event Log Screen of Subscriber Module
Mesh and Access Point Module
The first screen displayed after Logging In is the System Status screen. You can always return to this screen by clicking
the Status button.
Figure 5-3 System Status Screen of Mesh and Access Point Module
The System Status screen provides the following information:
• System Status: This area provides system-level information, including the unit’s IP address and contact information.
• System Alarms: System traps (if any) appear in this area. Each trap identifies a specific severity level: critical, major,
minor, and informational.
NOTE: On APs with model numbers ending in -WD, an operating Country must be selected (during the Setup Wizard
or on the Configure > System tab). If a country has not been selected, an informational message will appear
in the System Alarms list, and you will be unable to configure interface parameters.
From this screen, you can also access the AP’s monitoring and configuration options by clicking on the buttons on the left
of the screen.