User's Manual Part 1

Basic Management of Subscriber Module MeshMAX 5054 Series User Guide
General Configuration Settings
56
• If the Reload button us pressed for 10-20 seconds and released, then reloading operation is not performed and the
operation is aborted.
• If the Reload button is pressed for 20 seconds and above, then the Subscriber module is reload state.
NOTE: Boot loader will display all events to the serial console, which will guide user to perform Relad functionality.
General Configuration Settings
• System Status: The status tab showing the system status is displayed automatically when you log into the Web
interface. It is also the default window displayed when you click the Status button on the left side of the window.
• System Configuration: The System Configuration window lets you change the unit’s country, system name, location
name, and so on (see the window to the right). The Country selection is required to enable the correct radio
parameters. The other details help distinguish this unit from other routers, and let you know whom to contact in case
of problems.
• IP Configuration: The IP Configuration window lets you change the unit’s IP parameters. These settings differ
between Routing and Bridge mode.
• Interface Configuration: The Interface configuration pages let you change the Ethernet and Wireless parameters.
The Wireless tab is displayed by default when you click the Interfaces tab.
• Ethernet: To configure the Ethernet interface, click Configure > Interfaces > Ethernet. You can set the
Configuration parameter from this tab for the type of Ethernet transmission. The recommended setting is
auto-speed auto-duplex.
• Wireless: To configure the wireless interface, click Configure > Interfaces > Wireless. For the Subscriber module,
the wireless interface is always in WORP Satellite mode (selected from the Interface Type drop-down box).
• VLAN Configuration: VLANs are configured on the Base Station Unit only.