User's Manual Part 1

Configuration MeshMAX 5054 Series User Guide
Advanced Configuration of Mesh and Access Point Module
125
• Mesh Mobility: Set this parameter to Fixed if the AP is statically placed, or to Mobile if the AP is mobile.
• QoS Policy Index: The index number of the QoS policy to be used by the Mesh radio. For more information on QoS,
see QoS.
• Disable Client Access on Mesh Radio: When this option is enabled, the AP will not accept clients on its Mesh radio.
When disabled, clients can link to the Mesh radio.
Advanced Mesh Parameters
Figure 6-19 Advanced Mesh Parameters
Click on the Advanced button on the Interfaces > Mesh page to access advanced Mesh parameters. The parameters
on the Advanced Mesh Parameters page are preconfigured with default settings that optimize the type of network
identified in the Mesh Mobility parameter on the previous page. Proxim recommends changing these values only if you
have advanced knowledge of Mesh networking.
Mesh Link Parameters
To reset these parameters to their default settings, click the Default button.
NOTE: Changes to these parameters require a reboot in order to take effect.
• Maximum Active Mesh Links: Select a number between 1 and 32 to configure the number of Mesh links that can be
connected to a single Mesh portal or Mesh AP, as follows: