User's Manual Part 1

Configuration MeshMAX 5054 Series User Guide

Advanced Configuration of Mesh and Access Point Module

To configure the AP using the HTTP/HTTPS interface, you must first log in to a web browser. See Logging In for

instructions.

You may also configure the AP using the command line interface. See CLI for Mesh and Access Point Module for more

information.

To configure the AP via HTTP/HTTPS:

3. Click the Configure button located on the left-hand side of the screen.

Figure 6-1 Configure Main Screen

4. Click the tab that corresponds to the parameter you want to configure. For example, click Network to configure the

Access Point’s TCP/IP settings.

Each Configure tab is described in the remainder of this chapter.

System

You can configure and view the following parameters within the System Configuration screen:

• Name: The name assigned to the AP.

• Country: The country in which the AP will be used. Note that some countries have two selectable options (one for

indoor use and one for outdoor use). Setting the country makes the AP automatically compliant with the rules of the

regulatory domain in which it is used by configuring the allowed frequency bands, channels, Dynamic Frequency

Selection status, Transmit Power Control status, and power levels.

NOTE: You must reboot the AP in order for country selection to take effect.

NOTE: Country selection is available only on APs with model numbers ending in -WD. If country selection is available,

however, it must be set before any interface parameters can be configured.

• Location: The location where the AP is installed.