User's Manual

HARDWARE AND SOFTWARE INSTALLATION

Notes:

Be sure to read the Release Notes ﬁ le on the product CD as it contains ▪

software version and driver information that may not have been available

when this document was produced.

Equipment is to be used with, and powered by, the power injector provided ▪

or by a power injector that meets these requirements:

UL-Listed/ITE (NWGQ) –

Limited Power Source Output per UL/IEC 60950 –

CE-marked –

Approved for Power-over-Ethernet –

Rated output, 48 Vdc/0.42 A –

Pinout follows 802.3af standard for mid-span devices –

IMPORTANT!

Before installing this product, see Safety and Regulatory Compliance

Information on the product CD for important information.

IMPORTANT!

All units must be installed by a suitably trained professional installation

technician or by a qualiﬁ ed installation service.

WARNING!

To ensure proper grounding, use the hole at the bottom point on the back

of each unit and the provided grounding screws to attach a ground wire of

at least 10 AWG stranded to each unit. Use proper wire grounding tech-

niques in accordance with local electric codes.

Click Setup Wizard to begin. The Setup Wizard supports the following 1.

navigation options:

Save & Next Button ▪ : Each Setup Wizard screen has a Save & Next

button. Click this button to submit any changes you made to the unit’s

parameters and continue to the next page. The instructions below

describe how to navigate the Setup Wizard using the Save & Next

buttons.

Navigation Panel ▪ : The Setup Wizard provides a navigation panel

on the left-hand side of the screen. Click the link that corresponds to

the parameters you want to conﬁ gure to be taken to that particular

conﬁ guration screen. Note that clicking a link in the navigation panel

will not submit any changes you made to the unit’s conﬁ guration on the

current page.

Exit ▪ : To exit from the Setup Wizard at any time, click Step 1:

Introduction on the navigation panel, and then click the Exit button.

CAUTION:

If you exit from the Setup Wizard, any changes you submitted (by

clicking the Save & Next button) up to that point will be saved to the

unit but will not take effect until it is rebooted.

Follow the prompts provided by the Setup Wizard to perform an initial 2.

conﬁ guration of the Mesh radio. See the MeshMAX 5054 User Guide for

more detailed Setup Wizard instructions and for advanced conﬁ guration

instructions.