User's Manual

Step 2: Unpack the Shipping Box

Unpack the unit and accessories from the shipping box.1.

Note the Ethernet and wireless MAC addresses of the unit, as well as the 2.

serial number. The serial number is required to obtain support from Proxim.

Keep this information in a safe place.

Set c. IP Address Type to Static.

Enter a static IP Address for the Mesh radio in the ﬁ eld provided. d.

You must assign the unit a unique address that is valid on your IP

subnet.

Enter your network’s e. Subnet Mask.

Enter your network’s f. Gateway IP Address.

Enter the SNMP read/write password in the g. Read/Write

Password ﬁ eld.

For new units, the default password is public.

Click h. OK to save your changes.

The Access Point will need to reboot to apply any changes you i.

made. When the reboot message appears, click OK to reboot the

device and return to the Scan List screen.

After allowing sufﬁ cient time for the device to reboot, click j.

Rescan to verify that your changes have been applied.

Click the k. Change button to return to the Change screen.

Click the l. Web Conﬁ guration button at the bottom of the

Change screen.

Proceed to the m.

Logging In section, below.

Logging In

Once the Mesh radio has a valid IP Address, you may use your web browser

to monitor and conﬁ gure the Mesh radio. (To conﬁ gure and monitor using the

command line interface, see the MeshMAX 5054 User Guide.)