User's Manual

Technical Specifications
Tsunami
®
800 and 8000 Series - Hardware Installation Guide 133
Products Category Specification
MP-8160-BSU
MP-8160-BS9
MP-8160-SUA
Input Voltage
y
Via RJ-45 Ethernet interface supplying 48 VDC and 0.67 A on Ethernet Port#1
y
12 V-DC through serial port (for diagnostic purpose)
y
Consumption 10 Watts typical (13.8 Watts maximum with one heater ON)
: Only one of the above input voltage options should be used at a time, to
power on the device. Combination of any two options, may damage the
device.
Output Voltage* 48VDC through Ethernet Port #2. Power Always On.
Power over
Ethernet Injector
y
Input: 100 – 250 V-AC (47 – 63 Hz)
y
Output: 48 V-DC at 0.67 A (32 Watts)
y
Pin-out: +48 V on pins 4/5, -48 V on pins 7/8
y
Size: 5.24x2.13x1.42 inches(133x54x36 mm)
y
Weight: 7 ounces (200 g)
y
Temp: 0 to 40º C
Products Category Specification
MP-8150-CPE
QB-8150-LNK-12
QB-8150-LNK-50
Input Voltage
y
Via RJ-45 Ethernet interface supplying 48 VDC and 0.40 A on Ethernet Port
y
12 V-DC through serial port (for diagnostic purpose)
y
Consumption 7 Watts typical (13.8 Watts maximum)
: Only one of the above input voltage options should be used at a time, to
power on the device. Combination of any two options, may damage the
device.
PoE Injector
y
Input: 100 – 250 V-AC (47 – 63 Hz)
y
Output: 48 V-DC at 0.40 A (19 Watts)
y
Pin-out: +48 V on pins 4/5, -48 V on pins 7/8
y
Size: 3.98 x 2.40 x 1.35 inches (101.0x61.5x32.2 mm)
y
Weight: 5.6 ounces (160 g)
y
Temp: 0 to 40º C