Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 178
Figure 5-100 TCP/UDP Port Filter
The Filter Control parameters determines if filter has to be applied or not on a TCP/UDP Port. By default, it is disabled. To
apply filters, select Enable and click OK.
5.10.4.1 TCP/UDP Port Filter Table
The TCP/UDP Port Filter table displays a list of default TCP/UDP ports and user-defined ports which can be enabled or disabled
as desired. By default, the device support 7 default TCP/UDP port filter entries.
Parameter Description
Protocol Name Represents the name of the service/protocol. Please note that the system throws an error
when an attempt is made to edit the default service/protocol name.
Port Number Represents the destination port number. Please note that the system throws an error when
an attempt is made to edit the port number.
Port Type Represents the port type (TCP, UDP, Both).
Filter Interface Represents the interface on which the filter is applied. The supported interfaces are,

Only Ethernet

Only Wireless

All Interfaces