Software Guide

Tsunami
®
800 & 8000 Series - Software Management Guide 223
Monitor
This chapter contains information on how to monitor the device by using Web interface. It contains information on the
following:
      
 B     C             
 D E            
       F )  
    (  
        )    
    B
'
   
'
  G  (           
 B H  
  I  
 )   
     
      %          
7.1 System
The System tab enables to view system specific information such as LED/RSSI Display.
: 'RSSI LED' feature is applicable only to 82x devices.
To view LED/RSSI Display, navigate to MONITOR > System. The LED/RSSI Display screen appears:
Figure 7-1 LED/RSSI Display
When the link is established, Received Signal Strength Indicator (RSSI) LEDs on the scaling mask glow. Scaling mask LEDs
indicate the received signal strength of the link. The more LEDs on the scaling mask glow, better is the signal.
To select the LED Display Status, navigate to Advanced Configuration > System. By default, RSSI Display mode is
enabled, if required the user can select the Disable (LEDs Off) mode. In Disable (LEDs Off) mode, all the 5 LEDs will be off.
– The LED behavior in RSSI Display mode is given below:

By default all the 5 LEDs will blink for an interval of 1 second to indicate the device is UP.

For a BSU, in order to monitor the SU link statistics, the user should first configure the wireless MAC address of
the SU. If the configured SU is registered with the BSU, then the LEDs will glow based on the RSSI value else all
the 5 LEDs will blink.