Software Guide

Management
Tsunami
®
800 & 8000 Series - Software Management Guide 222
To convert a QB to SU using Web Interface, do the following:
1. Navigate to MANAGEMENT > Convert QB to MP. The Convert QB to MP screen appears:
Figure 6-30 Convert QB to MP
2. Click OK.
3. Reboot the device for the changes to take effect.
:

A QB after converting to SU will function in SU mode only. It will accept only MP firmware for upgrade.

The version of the firmware being upgraded to should be 2.4.0 or later. If earlier version of the firmware is loaded,
the device will reset to factory default upon initialization and operate in QB mode.

When upgrading a converted device from Bootloader, it must be done using a QB image, as the device is licensed as
QB.

The conversion of the device from QB to SU requires a reboot.

In case of Method 1 (Web Interface) conversion, QB mode configuration will be deleted.

Reset to factory defaults, always results in the device initializing in QB mode.