Software Guide

Management
Tsunami
®
800 & 8000 Series - Software Management Guide 221
6.6 Reset to Factory
The Reset to Factory tab allows you to reset the device to its factory default state. When this operation is performed, the
device will reboot automatically and comes up with default configurations.
To reset the device to its factory defaults, navigate to MANAGEMENT > Reset To Factory. The Factory Reset screen appears:
Figure 6-29 Reset to Factory Defaults
Click OK, if you wish to proceed with factory reset, else click Cancel.
6.7 Convert QB to MP
The Convert QB to MP tab lets you convert a QB to SU so that the converted device can connect to a BSU and operate as a
SU.
This feature is applicable only to,

QB-8100-EPA which converts to a MP-8100-SUA

QB-8150-EPR which converts to a MP-8150-SUR

QB-8150-EPR-100 which converts to a MP-8150-SUR-100

QB-8200-EPA which converts to a MP-8200-SUA

QB-8250-EPR which converts to a MP-8250-SUR

QB-8151-EPR which converts to a SU

QB-825-EPR-50 which converts to a MP-825-CPE-50

QB-825-EPR-50
+
which converts to a MP-825-SUR-50
+
You can convert a QB to SU mode by using two methods:

Method 1: Web Interface

Method 2: Load an SU config file (retrieved from another SU) onto the QB device and then reboot.
: Even after conversion from QB to MP, the device description still shows as QB.