Manualshelf

Software Guide

ManualsBrandsProxim Wireless ManualsElectronics802.11 a/b/g/n Mini-PCI module
12345678910
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 180
To configure Storm Threshold Filter, navigate to ADVANCED CONFIGURATION > Filtering > Storm Threshold Filter. The
Storm Threshold Filter screen appears. This screen contains information about the threshold values per second of the
multicast and broadcast packets that can be processed for the interface(s) present in the device.
Figure 5-102 Storm Threshold Filter
Given below is the table which explains Storm Threshold Filter parameters and the method to configure the configurable
parameter(s):
After configuring the required parameters, click OK and then COMMIT.
5.10.6 WORP Intra Cell Blocking
The WORP Intra Cell Blocking feature restricts traffic between SUs which are registered to the same BSU. The two potential
reasons to isolate traffic among the SUs are:
To provide better security by isolating the traffic from one SU to another in a public space.
To block unwanted traffic between SUs to prevent this traffic from using bandwidth.
Parameter Description
Interface Allows to configure the type of interface on which filtering has to be applied. The Storm
Threshold filter can be used to filter the traffic on two types of interfaces: Ethernet or
Wireless. By default, Storm Threshold filtering is disabled on both Ethernet and Wireless
interfaces.
Multicast Threshold Allows to configure the threshold value of the multicast packets to be processed for the
Ethernet or Wireless interface. Packets more than threshold value are dropped. If threshold
value for multicast packets is set to '0', filtering is disabled. The default Multicast
Threshold value is 0 per second.
Broadcast Threshold Allows to configure the threshold value of the broadcast packets to be processed for the
Ethernet or Wireless interface. Packets more than threshold value are dropped. If threshold
value for broadcast packets is set to '0', filtering is disabled. The default Broadcast
Threshold value is 0 per second.
: Intra Cell Blocking is applicable only to a BSU in Bridge Mode only.