Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 48
5.1 System
The System tab enables to configure system specific information.
To configure system specific parameters, navigate to ADVANCED CONFIGURATION > System. The System screen appears:
Figure 5-1 System Configuration
Given below is the table which explains System parameters and the method to configure the configurable parameter(s):
Parameter Description
Radio Mode Represents the radio mode of the device. Based on the SKU, the radio mode is set to either
BSU, SU, End Point A or End Point B.
In a BSU device, the radio mode can be changed from BSU to SU and vice versa. Also, in an
End Point A device, the radio mode can be changed from End Point A to End Point B and
vice versa. But note that a change in radio mode will reset wireless and WORP parameters
of the device after reboot.
Frequency Domain A valid frequency domain must be set before the device can be configured with any other
parameters. Selecting a frequency domain makes the device compliant with the allowed
frequency bands and channels for that regulatory domain. See
        j x   k    k  {

 k     
.
Network Mode The device can be configured in two network modes: Bridge and Routing. By default, the
network mode is Bridge mode.