Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 128
Select the Operation Type as either Allow or Deny.
·
Allow: Allows only the SUs/End Point Bs configured in the MAC Access Control Table to access the wireless network.
·
Deny: Does not allow the SUs/End Point B devices configured in the MAC Access Control Table to access the wireless
network.
Click OK, if you have changed the Operation Type parameters.
5.5.3.1 Add SUs/End Point B to MAC Access Control Table
To add entries to MAC Access Control table, click Add in the MAC Access Control screen. The MAC ACL Add Row screen
appears:
Figure 5-56 MAC ACL Add Row
1. Type the MAC Address of the SU/End Point B.
2. Add comments, if any.
3. Select the Entry Status as either Enable or Disable.
4. Next, click Add.
:
·
The maximum number of SUs/End Point Bs that can be added to the MAC ACL table is 250.
·
Either RADIUS MAC or Local MAC can be enabled at one time.
5.5.3.2 Edit the existing SUs/End Point B from MAC Access Control Table
To edit the existing SUs/End Point B from MAC Access Control Table, edit parameters from the MAC Access Control Table in
MAC Access Control screen and click OK.