User's Manual

Advanced Configuration
Figure 5-45 QoS Class Add Entry
b. Specify the QoS Class Name, Service Flow Name PIR Rule Name Priority and Entry Status and click Add.
Parameter Description
Class Name Specifies the Name of the QoS Class. This name length can range from 1 to 32 characters.
: Special characters - = \ \"\ ' ? \\ / space are not allowed.
Service Flow Name Specifies the Service Flow to be associated with the QoS Class. Select one of the possible
SFCs that have been previously configured in the SFC List.
PIR Rule Name Specifies the PIR Rule need to be associated with this Service Flow. Select one of the
possible PIRs that have been previously configured in the PIR List.
Priority Specifies priority or order of execution of PIRs during packet identification process.
The PIR priority is a number that can range from 0-255, with priority 255 being executed
first, and priority 0 being executed last. The PIR priority is defined within a QoS class, and
can be different for the same PIR in some other QoS class. If all PIRs within one QoS class
have the same priority, the order of execution of PIR rules will be defined by the order of
definition of SFCs, and by the order of definition of PIRs in each SFC, within that QoS class.
Entry Status Specifies the status of the QoS Class as enable/disable.
Adding Service Flows in QoS Class
1. Click on the corresponding Details of the QoS Class for adding more Service Flows. Each QoS Class can have
maximum 8 Service Flows. At least there should be one service flow per QoS Class. The following screen is displayed to
configure the new SFC entry inside the QoS Class.
2. Click OK.
Tsunami® 8100 Series - Software Management Guide 93