User's Manual

Advanced Configuration
Parameter Description
Max Messages in Specifies the maximum number of messages that can be sent in a burst. This value ranges
Burst from 1 to 16.
: Reducing the number of messages impacts the throughput.
Entry Status Specifies the Service Flow status.
5.6.2.3 QoS Class Configuration
1. Click ADVANCED CONFIGURATION > QoS > Class List. Five predefined QoS Classes are displayed in this page.
You can configure maximum 8 entries. QoS Class Name should be unique. This QoS Class can be referred in the
Default QoS Class or L2 Broadcast QoS Class. Any QoS Class referred cannot be deleted.
2. Click OK.
Figure 5-44 QoS Class Details
Parameter Description
Default QoS Class This parameter specifies the QoS Class profile that needs to be associated with an SU or
End Point B which is not listed in the QoS SU or End Point B List but connected.
L2 Broadcast QoS This parameter specifies WORP to use this particular class for WORP broadcast facility.
Class
L2 Broadcast QoS Class is valid only for Downlink Direction. QoS Class assigned to this
profile should have at least one Downlink SFC.
4. Add a New QoS Class:
a. Click Add to add new entry. The following screen appears for configuring the New Class Entry.
Tsunami® 8100 Series - Software Management Guide 92