User's Manual

Advanced Configuration
Parameter Description
Rule Name This parameter specifies the Name of the Packet Identification Rule (PIR) and can have a
length of 1-32 characters.
ToS Rule This parameter is used to enable or disable a TOS rule. Enter the values for the following to
specify the ToS-related configuration:
• ToS Low
• ToS High
• ToS Mask
Ether Priority Rule This parameters is used to enable or disable 802.1p priority rule. Enter the values for the
following to specify 802.1p priority configuration:
• Priority Low
• Priority High
VLAN Rule This parameters allows to enable or disable VLAN rule. Enter the VLAN ID when the VLAN
rule is enabled.
PPPoE Encapsulation This parameter is used to classify PPPoE traffic.
• If you Enable/disable the PPPoE Configuration, it will automatically disable the
Ether Type Rule. User can configure it again by enabling Ether Type Rule.
• When PPPoE Encapsulation is enabled, incoming packet will be checked again
Ether value “0x8864” and look for PPPoE Protocol Id value “0x0021”(IP Protocol)
by default. User can modify the PPPoE Protocol Id. All other classification rules
which are specified in the PIR rule will work only if the PPPoE Protocol Id is
“0021”.
• Ether Value is not valid when PPPoE Encapsulation is enabled.
Ether Type Rule This parameters is used to enable or disable Ether Type rule. Enter the values for the
following to specify the Ether Type rule related configuration:
• Ether Type
• PPPoE Protocol Id
• Ether Value
:
• PPPoE Protocol Id is not valid if PPPoE Encapsulation is disabled.
• Ether Value is not valid if PPPoE Encapsulation is enabled.
Adding Protocol ID
a. Navigate to ADVANCED CONFIGURATION > QoS > PIR List. Click Details. The Qos PIR Edit Entry screen
appears.
b. Navigate to Protocol Id Entries tab and then click Add to add a new Protocol entry. The following screen
appears.
Tsunami® 8100 Series - Software Management Guide 86