User's Manual

Advanced Configuration
Figure 5-30 QoS PIR TCP/UDP Port Entries
To Add a New PIR TCP/UDP Port Entry,
a. Navigate to ADVANCED CONFIGURATION > QoS > PIR List > TCP/UDP Port Entries. The QoS PIR TCP/UDP
Port Entries screen appears.
b. Click Add on the QoS PIR TCP/UDP Port Entries screen to add a new entry. The following screen appears for
configuring the IP Address entry details.
Figure 5-31 QoS PIR TCP/UDP Port Add Entry
c. Provide the Start Port, End Port, Entry Status details and click Add. Comment field can be used to identify when
this particular entry is referred in PIR Rule or QoS Class.
5.6.2.1 QoS PIR Configuration
1. Navigate to ADVANCED CONFIGURATION > QoS > PIR List. The QoS PIR Entries screen appears. 18 predefined
PIR Rules are displayed in this page. You can configure a maximum of 64 entries. PIR Rule Name should be unique.
This PIR Rule can be referred in the QoS Class’s Service Flow Details. PIR rule referred by any QoS Class cannot be
deleted.
2. Click OK.
Tsunami® 8100 Series - Software Management Guide 82