User's Manual

Advanced Configuration
To configure the RADIUS Server profile, navigate to ADVANCED CONFIGURATION > Security > RADIUS. The following
RADIUS Server Profile screen appears:
Figure 5-23 Configuring RADIUS Server Profile
Tabulated below is the table which explains RADIUS Server parameters and the method to configure the configurable
parameter(s
):
Parameter Description
Profile Name A name that represents the Radius Server profile. By default, it is Default Radius.
Max Retransmissions Represents the maximum number of times an authentication request may be retransmitted
to the configured RADIUS server. The range is 0 to 3. By default, it is set to 3.
Message Response Represents the response time (in seconds) for which that the BSU/End Point A should wait
Time for the RADIUS server to respond to a request. The range is 3 to 9 seconds. By default, it is
set to 3 seconds.
Re Authentication Represents the time period after which the RADIUS server should re-authenticate a SU or
Period an End Point B. The re-authenticate period ranges from 900 to 65535 seconds. By default,
the re-authentication period is set to 0.
Entry status A read-only parameter which displays the status of the RADIUS server profile as Enabled.
The Entry status cannot be disabled or edited.
Server Type For better accessibility and reliability, you can configure two RADIUS servers:
1. Primary RADIUS Server
2. Secondary RADIUS Server
The secondary RADIUS server serves as backup when the primary RADIUS server is down or not
reachable.
IP Address Represents the IP address of the primary and secondary RADIUS servers.
Tsunami® 8100 Series - Software Management Guide 72