User's Manual

Advanced Configuration
: Configure the same security profile on the either ends to establish a connection.
To configure the Wireless security profile, navigate to ADVANCED CONFIGURATION > Security > Wireless Security. The
Wireless Security Configuration screen appears:
Figure 5-20 Wireless Security Configuration
Tabulated below is the table which explains Wireless Security parameters:
Parameter Description
Profile Name Specifies the security profile name. By default, it is WORP Security.
Entry status Enables a user to either Enable or Disable the security profile on the device.By default, it
is enabled.
Edit Enables you to edit the existing security profiles. Click Edit to modify any of the security
profile parameters.
After configuring the required parameters, click OK and then COMMIT.
5.5.1.1 Creating a New Security Profile
To create a new security profile, click Add in the Wireless Security Configuration screen. The following Wireless Security Add
Row screen appears:
Figure 5-21 Creating a New Security Profile
Tsunami® 8100 Series - Software Management Guide 69