User's Manual

Advanced Configuration
Figure 5-17 Basic DDRS Configuration
The DDRS Configuration is classified under two categories, namely, Basic and Advanced.
Basic Configuration
Under Basic Configuration screen, you can configure the following parameters.
Parameter Description
DDRS Status Enables the user the either enable or disabled DDRS feature on the device. By default, it is
enabled on the device.
Stream Mode Select the stream mode as either Auto, Single or Dual. By default, the Auto mode is
selected. Based on the selected stream modes, DDRS dynamically chooses the data rate.
• Dual: Select Dual, for higher throughput.
• Single: Select Single, for reliability and longer range.
• Auto: When configured to Auto, DDRS decides on the stream modes based on the
environment conditions.
: Stream Mode is not valid in legacy mode.
Maximum Rate Represents the maximum data rate that DDRS can dynamically choose to provide the best
possible throughput. The default value depends on the channel bandwidth and the
number of streams.
: A change in Frequency Domain, Channel Bandwidth, Guard Interval and Data
Stream will reset maximum data rate to defaults.
After configuring the required parameters, click OK and then COMMIT.
Advanced Configuration
To view Advanced Configuration parameters, click Advanced tab in the DDRS Configuration screen. The following screen
appears depending on your device:
Tsunami® 8100 Series - Software Management Guide 65