User's Manual

Advanced Configuration
Figure 5-16 Manual Blacklist
Select the channels that you want to blacklist by entering the start and end channels in the Start Channel and End Channel
boxes
respectively.
Next, click Add. All the selected channels are added to the Blacklisted Channels table.
To remove any blacklisted channel, enter the Start and End Channel of the blacklisted channels and then click Remove
button.
To refresh channel entries, click Refresh.
5.4.5 DDRS
Dynamic Data Rate Selection (DDRS) feature adjusts the transmission data rate to an optimal value to provide the best
possible throughput according to the current communication conditions and link quality.
The factors for adjusting the transmission data rate are,
1. Remote average Signal-to-noise (SNR) ratio
2. Number of retransmissions
DDRS can be configured separately on each device (BSU mode/ SU mode /End Point A mode/ End Point B mode).
5.4.5.1 DDRS Configuration
To configure DDRS on the device, navigate to ADVANCED CONFIGURATION > Wireless > Interface 1 > DDRS. The DDRS
Configuration screen appears:
Tsunami® 8100 Series - Software Management Guide 64