User's Manual

Advanced Configuration
Parameter Descriptions
Legacy Mode When Legacy Mode is enabled, the BSU can interoperate with the legacy products of the
Tsunami MP.11 family: MP.11 5054 series, 5012 series, 2454 series and so on.
By default, it is disabled.
: Applicable only to Tsunami® MP-8100-BSU.
After configuring the required parameters, click OK and then COMMIT.
Reboot the device, if you have changed any of the Wireless Interface parameters with asterisk (*) symbol marked against
them.
Advanced
To view Advanced parameters, click Advanced tab in the Wireless Interface Properties screen. The following screen
appears:
Figure 5-11 Advanced Wireless Properties
The following table lists the Advanced Wireless properties parameters and their description. Note that these parameters are
read-only and can be configured only through CLI or SNMP.
Parameter Description
ATPC Lower Margin SNR Upper Limit = Maximum Optimal SNR
and SNR Initial = SNR Upper Limit - ATPC Upper Margin
ATPC Upper Margin SNR Lower Limit = SNR Initial - ATPC Lower Margin
ATPC Algorithm, after reducing the power to honor the Maximum EIPR limit, adjusts the
power based on Maximum Optimal SNR, ATPC Upper Margin and ATPC Lower Margin. To
begin with, ATPC will adjust the power to bring the SNR to SNR Initial and adjusts power
only when the current SNR goes beyond the SNR Upper Limit and SNR Lower Limit.
Click Local SNR-Table, to view the optimal SNR values that are exchanged with the peer for optimal throughput.
Tsunami® 8100 Series - Software Management Guide 56