Manualshelf

User's Manual

ManualsBrandsProxim Wireless ManualsElectronicsTsunami 8000 Point-to-Point and Point-to-multipoint Product
41424344454647484950
Advanced Configuration
Parameter Description
Auto Multi Frame Auto Multi Frame Bursting feature takes effect only when Multi Frame Bursting feature is
Bursting Enabled.
When this feature is enabled, the device monitors all active QoS Service Flow Classes and
determines the highest priority QoS Service Flow Class for every wireless connection. The device
enables the burst transmission for the active highest priority QoS Service Flow Class and
disables the burst transmission for other active lower priority QoS Service Flow Classes. By default,
Auto Multi Frame Bursting is Enabled on the device.
:
• When using Software Version 2.4.0, it is recommended to disable Auto Multi
Frame Bursting.
• Though Auto Multi Frame Bursting configuration is not applicable from
SU/End Point B, the SU/End Point B does Auto Multi Frame Bursting under the
control of BSU/End Point A respectively.
Registration Timeout Represents the maximum time for a SU to register with a BSU or vice versa, or an End Point
B to register with an End Point A or vice versa. The registration timeout value can be set in the
range 1 to 10 seconds. The default registration timeout value is 10 seconds.
Retry Count Represents the maximum number of times the data is retransmitted by the transmitter
over the wireless medium, if acknowledgement from the peer is not received. The Retry
Count parameter can be configured in the range 0 to 10 seconds. By default, it is set to 3.
DDRS Status
: Applicable only when DDRS is enabled.
It is a read-only parameter that displays the status of the DDRS feature. For more details
refer to DDRS.
Tx Rate Represents the modulation rate at which the packets are transmitted from the wireless
device. Please note that the a change in Channel Bandwidth, Guard Interval and Number
of Data Streams will reset Tx rate to default values.
: Applicable only when the DDRS is disabled on the device. See DDRS.
Input or Output This parameter limits the data received or transmitted to the wireless interface. It limits the
Bandwidth Limit data from a minimum of 64 Kbps to the maximum value specified in the License File.
: Input/Output Bandwidth throttling does not throttle broadcast/multicast traffic.
These traffic can be trottled by the Maximum Information Rate (MIR) /
Committed Information Rate (CIR) configured for DL-L2 Broadcast BE in QoS
Service Flow. See QoS Service Flow Configuration (SFC)
Tsunami® 8100 Series - Software Management Guide 47