User's Manual

Advanced Configuration
Figure 5-9 WORP Configuration
Tabulated below is the table which explains WORP parameters and the method to configure the configurable parameter(s):
Parameter Description
Mode Represents the device type (BSU, SU, End Point A or End Point B)
BSU Name Applicable only to SU. It specifies the name of the BSU to which a SU can establish wireless
connection. If this parameter is left blank, SU can establish a link with any BSU.
End Point A Name Applicable only in End Point B mode. It specifies the name of the End Point A to which End
Point B can establish wireless connection. If this parameter is left blank, End Point B can
establish a link with any End Point A.
Network Name It is a unique name given to a logical network. Devices only within this logical network can
establish wireless connection.
The Network Name can be of 2 to 32 characters in length. By default it is MY_NETWORK.
Tsunami® 8100 Series - Software Management Guide 45