User's Manual

Advanced Configuration
Parameter Description
IP Address Represents the IP address of the Ethernet interface.
By default, the static IP address for Ethernet1 is set to 169.254.128.132 and for Ethernet2 it is
set to 169.254.129.132.
You can manually change the IP address.
Subnet Mask Represents the subnet mask of the Ethernet interface.
By default, the static subnet mask is set to 255.255.255.0. You can manually change the
subnet mask.
Wireless
IP Address Represents the IP address of the wireless interface.
By default, the static IP address is set to 169.254.130.132. You can manually change the IP
address.
Subnet Mask Represents the subnet mask of the wireless interface.
By default, the static subnet mask is set to 255.255.255.0. You can manually change the
subnet mask.
Default Gateway IP Address
IP Address Represents the gateway IP address of the device.
By default, the Gateway IP address is set to 169.254.128.132. You can manually change
the gateway IP address.
DNS
Primary IP Address Represents the IP Address of the Primary DNS Server.
Secondary IP Address Represents the IP Address of the Secondary DNS Server.
After configuring the required parameters, click OK, COMMIT and then REBOOT.
:
• To obtain dynamic IP address of the SU over WORP,
• Scenario 1: When BSU and SU are in Bridge Mode with DHCP Client enabled in SU, and if DHCP server is
behind BSU, SU will get the IP Address over WORP.
• Scenario 2: When BSU is in Routing Mode and SU is in Bridge mode and DHCP server is in a different network than
SU, then we need to configure DHCP relay in BSU to get the IP for SU over WORP.
• Scenario 3: When BSU is in Routing mode and SU in Bridge mode with DHCP server running on wireless
interface of BSU, then SU will get the IP address from BSU.
Tsunami® 8100 Series - Software Management Guide 39